Tips

A successful cryopreservation program has become the onus of fertility clinics all over. Importantly, as ‘freeze all’ cycles are slowly making inroads, the dependence on an effective cryopreservation program is the need of the hour.
Vitrification has been the choice lately for cryopreservation and can have slight variations depending upon the temperature, cryo devices and the brand of the media. Nevertheless, the basic principle and protocol are similar considering all these factors. Vitrification procedure is accomplished with the help of the available Vitrification media. The embryos are subjected to ES (Equilibration media) followed by its incorporation into VS (Vitrification media) before they are loaded on to a cryo device and plunged into liquid nitrogen. As an embryologist, it has always been found that Vitrification is more daunting to master than ICSI or other procedures. Unfortunately, there isn’t an exhaustive learning module with respect to the same. Fertility clinics do not follow a standard training program for Vitrification which may result into incompetency of the operator, poor survival rates and fluctuations in results!
Vitrification of oocytes
The final step of embryo loading is the centerpiece of the whole procedure and the entire Vitrification program rests on the premise of that crucial last one minute. Naturally, the main focus will be on the last step which includes activities such as washing embryos in VS, loading them with minimal media on the cryo device and finally draining excessive media and plunging them into liquid nitrogen. The step is not difficult but certainly is meticulous considering the microscopic aspects of the same coupled with the race with time.
The biggest challenge in Vitrification is the composite of speed with time! However, the technique can be effectively implemented after an extensive stepwise way to learn it by self-devising a good training environment.
Firstly, when you get acquainted with the technique, just learning the protocol isn’t the key. There has to be an understanding of the science behind it. It has been seen people panicking when they see embryos shrinking in ES!
Secondly, for starters, it is recommended for embryologist to be familiar with all the components of a Vitrification system. The goal here would be to do things perfectly without time constraints. The last major step can be broken into mini steps for better acclimatization. Embryologist can learn to adjust the coarse knob of the microscope to pick up the embryos after they float owing to change in viscosity in VS, the focusing of the cryotop under the microscope, the placement of the hand, learning the process of washing and finally gaining the ability to load the embryos!
Thirdly, once you have perfected the step, time will come into the picture. Then the use of stop watch and practicing loading in its required time becomes the focus. Initially, the loading time may exceed even two mins. With practice, slowly, you will reduce the necessary time and finally place yourself in the stipulated range of sixty to ninety seconds! This practice can be done with degenerated oocytes.
Fourthly, once you have taken care of the time, the next natural factor will be survival! This is the stage where you will use discarded embryos and actually freeze them as if you are performing an actual procedure. Here, even the ES will come into your practice and you will observe intricate details such as the reaction of the embryos with the media. At this stage, thawing technique will also be incorporated as it too contributes to the overall survival. The results can be recorded and it will give an insight into the overall improvement of the operator.
Finally, once you are done with survival of embryos, it is always recommended to freeze for embryo donation patients as ED cycle harbors the best quality embryos. Blastocysts should be considered more in the initial phase of freezing which survives better than say day 2 or day 3 embryos. This can be furthered by increasing the number of cryo devices progressively corresponding with checking performance of the previously frozen cryo devices simultaneously.
This comprehensive way of learning Vitrification may take six months overall depending upon the cycles happening in a fertility clinic which certainly affects the availability of gametes and resources(such as expired media for practice). It can help attain better proficiency over the technique and the program can be robustly standardized in a working fertility center itself. Vitrification is a gateway for the embryos to hibernate in an ice age and maybe we can make their journey qualitatively smooth!
Learn process of vitrification of embryos, Advanced course in cryopreservation, IVF training for Gynaecologist and Embryologist, Hands-on IVF IUI ICSI training courses and how to set up IVF and IUI Laboratory in India for Gynaecologist and Embryologist at http://www.ivftraining.com

Embryology Academy for Research